<button id="bbofb"><acronym id="bbofb"></acronym></button>

      <form id="bbofb"><wbr id="bbofb"><kbd id="bbofb"></kbd></wbr></form>

      1. <rp id="bbofb"></rp>
      2. <dd id="bbofb"><pre id="bbofb"></pre></dd>

        老化測試設備

        咨詢熱線

        18566398802
        首頁 > 標準大全 > ASTM D4459標準詳情
        相關測試儀器

        ASTM D4459測試標準

          本頁面標準信息均來源于網絡收集,或由參與標準制定的供應商提供,只作為參考使用。我們愿意和您交流ASTM D4459標準細節信息或ASTM D4459測試方法,歡迎致電【18566398802】

        ASTM D4459標準介紹

        ASTM D4459是室內用塑料氙燈曝露測試的標準測試方法:

        ASTM D4459規定了依照測試方法G151和G155,用配備窗玻璃濾光器的氙燈設備對塑料進行暴露測試的具體程序和測試條件,以評估室內用塑料的穩定性。ASTM D4459目前還沒有對應的ISO 測試標準。

        Q-sun氙燈試驗箱 ASTM D4459測試方法

        ASTM  D4459測試方法

        附ASTM D4459英文版本(摘抄)

        4.1 This practice is intended to simulate the effects produced by exposure to solar radiation through glass. This practice uses exposure in a xenon-arc device equipped with window glass filters and operated in accordance with Practices G151 and G155.

        Note 2—Practice D4674 describes exposures in a device that uses a combination of fluorescent “cool white” and ultraviolet (UV) lamps to simulate the effects of exposures to indoor fluorescent light and window glass filtered daylight.

        4.2 Warning—Variation in results may be expected when operating conditions are varied within the accepted limits of this practice. Therefore, all references to the use of this practice must be accompanied by a report prepared in accordance with Section 9 that describes the specific operating conditions used. Refer to Practice G151 for detailed information on the caveats applicable to use of results obtained in accordance with this practice.

        Note 3—Additional information on sources of variability and on strategies for addressing variability in the design, execution and data analysis of laboratory accelerated exposure tests is found in Guide G141.

        4.3 Test results will depend upon the care that is taken to operate the equipment in accordance with Practice G155. Significant factors include regulation of line voltage, temperature and humidity control, and condition and age of the lamps and filters.

        4.4 Reproducibility of test results between laboratories has been shown to be good when the stability of materials is evaluated in terms of performance ranking compared to other materials or to a control.4,5 Therefore, exposure of a similar material of known performance (a control) at the same time as the test materials is strongly recommended. It is recommended that at least three replicates of each material be exposed to allow for statistical evaluation of results.

        1. Scope

        1.1 This practice covers specific procedures and test conditions that are applicable for exposure of plastics in window glass-filtered xenon-arc devices in accordance with Practices G151 and G155 for evaluating the stability of plastics intended for use in indoor applications.

        1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

        Note 1—There is no known ISO equivalent to this practice. 

        Referenced ASTM Standards(相關標準)

        D1729 Practice for Visual Appraisal of Colors and Color Differences of Diffusely-Illuminated Opaque Materials

        D2244 Practice for Calculation of Color Tolerances and Color Differences from Instrumentally Measured Color Coordinates

        D3980 Practice for Interlaboratory Testing of Paint and Related Materials

        D4674 Practice for Accelerated Testing for Color Stability of Plastics Exposed to Indoor Office Environments

        D5870 Practice for Calculating Property Retention Index of Plastics

        E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

        G113 Terminology Relating to Natural and Artificial Weathering Tests of Nonmetallic Materials

        G141 Guide for Addressing Variability in Exposure Testing of Nonmetallic Materials

        G147 Practice for Conditioning and Handling of Nonmetallic Materials for Natural and Artificial Weathering Tests

        G151 Practice for Exposing Nonmetallic Materials in Accelerated Test Devices that Use Laboratory Light Sources

        G155 Practice for Operating Xenon Arc Light Apparatus for Exposure of Non-Metallic Materials

        G169 Guide for Application of Basic Statistical Methods to Weathering Tests

        ASTM D4459-06標準

        1. Scope

        1.1 This practice covers specific procedures and test conditions that are applicable for exposure of plastics in window glass-filtered xenon-arc devices in accordance with Practices G 151 and G 155 for evaluating the stability of plastics intended for use in indoor applications.

        This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

        Note 1 - There is no known ISO equivalent to this practice.

        ASTM D4459-99標準

        1. Scope

        1.1 This practice covers the procedure applicable when Practice G26, Method C, is employed for exposing plastics to a Xenon lamp, in attempting to predict long-term color-fastness of plastics for use in indoor areas. Such exposure may involve illumination from fluorescent, incandescent, or window-filtered sunlight sources, and thermal radiation.

        1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

        Note 1-There is no similar or equivalent ISO standard.

        溫馨提醒:本ASTM D4459可能存在更新的版本,建議尋找ASTM D4459的發行商確認。

        符合 ASTM D4459 標準的
        老化試驗箱

        • 氙燈老化試驗箱圖片 氙燈老化試驗箱

          Q-SUN Xe-3-HSE氙燈老化試驗箱具有全光譜光照功能、濕度控制以及噴淋功能,其命名規則為濕度控制(H)、噴淋(S)。

          Q-SUN Xe-3-HSE 馬上詢價
        • 太陽光老化試驗箱圖片 太陽光老化試驗箱

          Q-SUN Xe-3-HBSE是一款支持背部噴淋的氙燈老化試驗箱,可將水同時噴灑在樣品的正面和背面。

          Q-sun Xe-3-HBSE 馬上詢價
        • 氙燈老化試驗機圖片 氙燈老化試驗機

          Q-SUN Xe-3-HCE是一款具有全光譜光照模擬、濕度控制以及制冷功能的氙燈老化試驗機,其命名規則為濕度控制(H)、制冷功能(C)。

          Q-SUN Xe-3-HCE 馬上詢價
        • 氙燈耐氣候試驗箱圖片 氙燈耐氣候試驗箱

          Q-SUN Xe-3-HDSE氙燈耐氣候試驗箱具有濕度控制、以及雙噴淋功能,其命名規則為濕度(H)、雙噴淋(D)、噴淋(S)。

          Q-SUN Xe-3-HDSE 馬上詢價
        • 氙燈耐候試驗箱圖片 氙燈耐候試驗箱

          Q-SUN Xe-3-HSCE氙燈耐候試驗箱同時具有濕度控制、噴淋以及制冷功能,其命名規則為濕度(H)、噴淋(S)、制冷(C)。

          Q-SUN Xe-3-HSCE 馬上詢價
        • 氙燈加速老化箱圖片 氙燈加速老化箱

          Q-SUN Xe-3-HE氙燈加速老化箱是一款經濟的氙燈加速老化箱,具備有濕度控制功能,但是該型號的產品不具備水噴淋功能。

          Q-SUN Xe-3-HE 馬上詢價
        近期文章
        亚洲av无码不卡免费在线观看

            <button id="bbofb"><acronym id="bbofb"></acronym></button>

            <form id="bbofb"><wbr id="bbofb"><kbd id="bbofb"></kbd></wbr></form>

            1. <rp id="bbofb"></rp>
            2. <dd id="bbofb"><pre id="bbofb"></pre></dd>